CMM Calibration Serving Indianapolis and Central Indiana
Indianapolis CMM Calibration and Repair
Request a quote for on-site or ship-in verification.
Request a quotation
Performance verification, not a slogan
A CMM calibration is a performance verification against ISO 10360 or ASME B89.4.1, run alongside geometric adjustment and, where the controller allows it, an update to the volumetric error map.
As-found data is recorded before any adjustment. Results are issued with reference standards, reported uncertainty and a stated decision rule.
Two routes to service
Machines are verified on-site at the shop floor, or removed to a laboratory environment for ship-in work when volume, access or downtime favors it.
Either route is completed under ISO/IEC 17025:2017 by laboratories holding the relevant scope of accreditation for the machine's range and reported uncertainty.
Services
CMM calibration and repair is the core offer. Programming and gage calibration are scheduled alongside it so a quality department consolidates one visit instead of three vendors.
- 01
CMM Calibration
Performance verification, geometric adjustment and error-map compensation for bridge, gantry and cantilever CMMs.
View → - 02
CMM Programming
Offline and online part programs written to measure what the drawing requires, not just to run.
View → - 03
Gage Calibration
Calipers, micrometers, gage blocks and ring and plug gauges calibrated on the same interval as the CMM.
View →
Service areas across Indiana and the Greater Midwest
Indianapolis sits at the center of a powertrain and high-temperature alloy manufacturing base running through Columbus, Kokomo, Lafayette, Terre Haute, Fort Wayne and Elkhart.
Coverage extends across the metro and into the surrounding county lines that feed engine, transmission and turbine component suppliers.
Why Indianapolis CMM Calibration and Repair
- 01
As-found before adjustment
Every result is recorded prior to any correction, supporting an impact assessment if needed.
- 02
Scope-matched laboratories
Each job is checked against a laboratory's published scope before it is booked.
- 03
On-site or ship-in
Machines are verified in place or removed to a controlled environment, by volume and access.
- 04
Certificates built for audit
Traceability, uncertainty and decision rule are stated, not implied.
Common questions
What does ISO 10360-2 actually test?
Five calibrated test lengths are measured three times each in seven positions across the volume, 105 measurements total, checking length measurement error against a stated maximum permissible error.
Can calibration be done on-site, and how long is the machine down?
On-site verification is routine for bridge and gantry CMMs. Time on site depends on volume and axis count and is confirmed at quote, not estimated in advance.
What happens if the machine fails as-found?
As-found results are recorded before adjustment and reported. Where a value falls outside limit, a reverification allows a re-measure of that length before any repair or compensation update proceeds.
Discuss CMM Calibration Requirements
Send the machine make, model and volume for a scoped quote.