Services
Services
The measurement and calibration disciplines available through Indianapolis CMM Calibration and Repair.
What Is Offered
CMM calibration and repair is the core offer. Programming and gage calibration are scheduled alongside it so a quality department consolidates one visit instead of three vendors.
Services Offered
Each discipline below has its own page setting out method, scope and what a request should contain.
- 01
CMM Calibration
Performance verification, geometric adjustment and error-map compensation for bridge, gantry and cantilever CMMs.
View → - 02
CMM Programming
Offline and online part programs written to measure what the drawing requires, not just to run.
View → - 03
Gage Calibration
Calipers, micrometers, gage blocks and ring and plug gauges calibrated on the same interval as the CMM.
View →
How the Work Runs
Work is performed under ISO/IEC 17025:2017. Methods, ranges and measurement points are confirmed against the request before work begins, and results are issued on a certificate or report that states the method used, the conditions of measurement and the associated uncertainty.
Coverage across Indianapolis, IN and the wider Indiana and the Greater Midwest area is listed on the service areas page. The standards, traceability and management arrangements behind the work are set out on the quality system page.
Have a specific item to quote?
Send the item, measurement points, tolerances and required turnaround, and a written quotation is prepared and returned.